Note:
Do not install the batteries backwards. You can permanently damage the sensors. The solar panel
does not charge the batteries, so rechargeable batteries are not needed or recommended.
Note:
We recommend installing Lithium AA batteries for sensors.
The sensor LED indicator will light for 3 seconds, and then flash once per 16 seconds thereafter. Each time
it flashes, the sensor is transmitting data.
Replace the battery door and push to tighten it.
Note:
If the sensor does not power up after inserting the batteries, press the reset button shown in
Figure 6.
Figure 6
3.3.2 Insert batteries into the thermo-hygrometer transmitter.
Remove the battery door on the back of
the sensor by removing the set screw, as shown in Figure 7.
Figure 7
1.
BEFORE
inserting the batteries, locate the dip switches on the inside cover of the lid of the
transmitter.
Figure 8 displays all four switches in the OFF position (factory default setting).
Figure8
