Starting up the system
The configuration label shows you the equipment included in your modular
BEETLE /S-II system.
The label is located on the underside of the BEETLE /S-II. The data
specified there are required for entering the setup parameters (see “Setup”
in the manual BEETLE POS Motherboard).
Start and runup behaviour
After installing the BEETLE /S-II, switch on the POS system on the rear side
and then press the ON/OFF button on the front panel.
The system first performs an automatic self-test to test its basic functions.
For example, you may see the following message (irrespective of processor
type) on the four-line cashier display or on the monitor:
xx/xx is the place holder of the BIOS version number
The system then determines the medium from which the operating system
and POS application are to be booted. Each medium is assigned a logical
drive according to the configuration of your BEETLE /S-II.
The following media can be assigned a drive:
n
Disk
n
Network
n
Hard disk
n
Flash disk
n
CD-ROM
START AND RUNUP BEHAVIOUR
42
WN ID xx/xx Date
