Winco SPECTRUM EMP-10, Инструкция по установке и эксплуатации, Страница: 6 / 20

6
Operation
INSTALLATION OF MIXER AGITATOR ATTACHMENT:
1. Place the stirring shaft in Mixer and rotate in clockwise direction.
ADDING MIXING INGREDIENTS:
WARNING
Overloading or not following the capacity chart will damage the
mixer and void the warranty. Refer to Capacity Chart section.
1. Add the appropriate mixing ingredients into the bowl.
2. Rotate bowl lift lever up until bowl lock into position.
3. Rotate bowl guard to the right until it locks into position.
ROTATION SPEED PARAMETERS:
STARTING & CHANGING SPEED:
1. Pull the gear speed control handle to position 1 before starting,
push the ON power switch.
2. Changing Speed: To change speed, push the OFF power switch
first, and then pull the speed control handle to the new position
(2 or 3).
WARNING
Never change speeds while mixer is running. Failure to do so will
damage the gears or other parts and WILL void the warranty.
Gear Speed Product Type
1 (Low) Heavy: mixing pizza, bread, donut doughs, etc.
2 (Medium) Medium: 2nd stage mixing for donut doughs, etc.
3 (High)
Light: whipping cream, egg whites, meringue
Model Speed of Stirring Shaft (r/min)
1 (low) 2 (medium) 3 (high)
EMP-10 108 195 355
EMP-20 w/hub 108 195 355
EMP-30 w/hub 91 166 282
3. Shutting down: When the operation is complete, push the OFF
power switch first, then pull the gear change hand lever to
position 1.
4. Rotate the bowl lift hand lever to the lowest point
5. Rotate bowl guard to the left until fully open
Accessories and Functions
• Whisk (Wire Whip): Used for stirring of liquid material, such as cream and egg. Recommended speed: mid or high speed.
• Flat Beater: Stirring of paste, powder and fragmental material, such as stuffing and cake dough.
Recommended speed: start with low speed, end with mid speed.
• Spiral Dough Hook: Stirring of sticky material, such as dough. Recommended speed: low speed.
NOTES
Please remember that this manual and the warning labels do not replace the need to be alert, to properly train and
supervise operators, and to use common sense when using this equipment.
Don’t put your hands into the stirring barrel during operation. Power supply should be disconnected before the mixer
attachment is going to be installed.
Don’t operate the mixer beyond the time limit to prevent reduction of its service life.
WARNING
If the equipment fails to function, please make sure that it is serviced by professional person or please turn to special
service point.
Mixer will NOT START unless:
• Unit is plugged into power supply
• Bowl is secure in up position
• Bowl safety guard is closed