Winco SPECTRUM EMP-10, Инструкция по установке и эксплуатации, Страница: 10 / 20

10
If your SPECTRUM™ Commercial Planetary Mixer does not operate, please check the following before placing a service call:
Troubleshooting
ISSUE MIGHT BE CAUSED BY RECOMMENDED SOLUTION
Mixer will not operate
Bowl guard not in closed position. Rotate guard to the right until fully closed
Bowl not raised. Raise bowl to highest position.
Power not connected properly.
Check all power connections. Plug into a live socket. (Do not use
extension cord)
Building circuit breaker is off. Check breaker box.
Internal overload tripped. Reset internal overload breaker on rear of unit
Gear not engaged.
Switch gear fully into position. (Mixer will not operate if the speed
control lever is in between positions)
Mixer stops during mixing cycle
Internal overload tripped. Reset internal overload breaker on rear of unit
Overloads Reduce product load and restart
The speed of mixing is too high or
using wrong agitator
Select correct agitator and speed setting
Mixer is noisy
Mixer is not installed on level surface. Adjust surface or relocate mixer
The agitator or bowl are deformed
Replace or change agitator or bowl
Abnormal noise and high
temperature from gearbox
Insufficient lubrication Add or replace gearbox grease
Oil leaking Seal ring are worn Replace seal rings
Service and Repair
THIS EQUIPMENT MUST ONLY BE SERVICED BY AN AUTHORIZED AGENT.
NOTE
Parts protected by the manufacturer or its agent are not to be adjusted by the installer unless the installer is an authorized service agent.
If you have any questions or problems DO NOT send unit to WINCO® without first contacting our customer service department.
See "Limited Warranty" section on page 18 for details.