6
Operation
Before using this equipment it must be cleaned and dried thoroughly. Clean all surfaces before use.
Failure to clean surfaces before using the unit could cause food contamination.
Always unplug the unit after every use and before cleaning. Unplug the unit when not in operation.
• Allow unit to cool completely before cleaning.
• Clean main body with a damp cloth and degreaser solution if desired.
• Allow to dry before turning the unit back on.
• Do not immerse the device completely in water to clean. The appliance should also NOT be cleaned with a water jet.
NOTE:
Proper cleaning instructions must be followed; otherwise, operation of the unit may be seriously impaired. Do not
wash parts in an automatic dishwasher.
WINCO authorized service personnel must perform any other servicing.
Cleaning & Maintenance
1. Attach legs and adjust the leg height, or install undermounted in desired location.
2. Route the power supply away from the heat source. It is recommended ziptieing them to the stand or other nearby
supports to a receptacle.
3. Plug power cord into a receptacle.
4. Turn on the unit via the power switch.
5. Turn off unit when not in use.
When installing a unit with a mounting bracket
(ESH-UM)
, install with the following clearances:
9” minimum between end of unit and any wall
12” min. between side of unit and any wall
16” min. between bottom of unit and counter
1-7/8” min. between top of unit and overhead surface
Do not clean when plugged in - HOT! Unplug the unit and wait for unit to cool before cleaning.
CAUTION:
