5
Note: Lid will drop into can and should be removed with
tongs or gloves to protect hand from sharp edges of lid.
Note: The maximum can height is 16”.
OPERATION
1. Lift handle into upright position and slide the can opener
above the work surface.
2. Carefully place can onto the base plate/work surface.
3. Raise the can opener 6” to 8” and with force bring the can
opener down to puncture top of can.
4. Lower handle and turn clockwise while keeping one hand on
the can. Keep turning until lid is cut out.
5. Raise handle to upright position and lift to remove open can.
If the unit fails to properly operate during its first use,
call Winco customer service at 973-295-3899 or
email at [email protected].
DO NOT send unit to WINCO without first contacting
our customer service department.
Note: The blade of this opener may be reversed for double
wear but should not be reshaped. A worn blade can cause
metal slivers. Never resharpen the blade. Replace blade
when it no longer cuts smoothly or when the can skips
against the gear.
Note: Turning the handle without a can in place will cause
damage to both the blade and gear. Excessive “Grind
Damage” to the blade and gear are not covered under
warranty.