4
PREPARATION
PERMANENT MOUNTING
STAINLESS STEEL TABLE
WOODEN TABLE
(STANDARD 2” THICK)
PORTABLE MOUNTING ON ANY SURFACE
1. Place the base plate on the stainless steel table in the
desired position where you want to secure the can
opener.
2. Mark the center of each of the three mounting holes on
the base plate. These three points will be your drilling
location.
1. Slide the base plate onto the work surface. Secure to the work
surface with the fixing screw.
2. Insert the can opener into the base. The can opener must be
inserted straight through the base opening.
1. Place the base plate on the wooden table in the desired
position where you want to secure the can opener.
2. Mark the center of each of the three mounting holes of
the base plate. These three points will be your drilling
location.
3. Drill through each point with a 9/32” drill bit.
4. Insert size 1/4 x 20 x 2-1/2” screws through the base
plate. Use the split washers and nylon lock nut provided.
5. Use a 7/16” socket, bow or open-end wrench to tighten
and secure the screws.
3. Drill a small starter hole on each marked point with a
1/8” cobalt or titanium drill bit that is specifically used
for drilling into stainless steel.
4. Complete drilling the holes for the screws by using a
9/32” cobalt or titanium drill bit that is specifically used
for drilling into stainless steel.
5. Insert 1/4-20 x 3/4” screws through the base plate and
secure with split washers and nylon lock nuts.
6. Use a 7/16” socket, bow or open-end wrench to tighten
and secure the screws.
Tools and hardware required (not included)
- 1/4-20 x 3/4” screws, split washers and lock nuts
- 1/8" cobalt or titanium drill bit
- 9/32" cobalt or titanium drill bit
- 7/16" socket, box or open-end wrench
Tools and hardware required (not included)
- 1/4-20 x 3/4” screws, split washers and lock nuts
- 9/32” drill bit
- 7/16” socket, box or open-end wrench
Note: To prevent the drill from slipping out of position,
place a piece of masking tape on each of the three
marked points. Then mark the points again on the
masking tape.