T h e n o n - c o n t a c t W C - c o n t r o l
P R O D U C T P R E S E N T A T I O N
Adjustment of flushing programs
SanTec FLUSH
Page 5
Adjustment of flushing programs (only possible in the first 10 sec. after initiation): as
soon as battery or mains adaptor will be connected
(program 2 factory-made pre-adjusted)
Diagnostics LED
Red LED flashes at
wide range reflex
during the first 5 minu-
tes after initiation.
Additional at battery
operated variant:
battery control LED
begins to flash when
battery becomes
empty.
12V version:
connection to power supply
6V version:
insert batteries
For changing the flushing program of an already adjusted WC-control, the power supply must
be disconnected (disconnect external power supply unit or remove the batteries) for at least
30 sec., afterwards a new programming is possible.
The device makes a selftest, then the diagnostics LED flashes 3 times quickly.
From that time there are 10 sec. for adjusting the flushing program.
Via
close range reflex
(hold hand approx. 2 cm in front of infrared window=> see picture) it
is now possible to choose between 3 different programs.
*
1 slow flash = program 1
no automatic flushing - via close range reflex only manual flushing releasable
**
2 slow flashes = program 2 (preset)
as program 1, but additional automatic flushing after leaving the WC
minimum stay time 15 sec.
***
3 slow flashes = program 3
as program 2, but additional intermediate flushes every 10 min. for handicapped areas
minimum stay time 15 sec.
Remove hand at the desired program - the control confirms the program by flashing twice
quickly.
Afterwards there are further 10 sec. for changing the flushing program again. After lapse of
this time, the device flashes 3 times quickly and it changes after 60 sec. into normal function.
1.
2.
3.
4.
5.
