30 Wall fitting
WimTec OCEAN W7
EN
OCEAN W7
Assembly
7
8
9
10
7.
Remove the spout fixing screw (size 3 Allen key).
8.
Place the brass spout pipe into the designated opening.
9.
Fasten the spout pipe in place using the fixing screw
(size 4 Allen key).
10.
Feed the connection cable (cable type: 2 x 0.2 - 0.5 - 1.5
mm
2
) into the flush-mount set and connect it to the power
supply (art. no. 117 899 or art. no. 113 792).
Attention: The
power must be switched off, and the power supply must
not be installed in the flush-mount set or the protected
zone!
11.
Configure the electrics module with the desired function
settings (see Page 29).
12.
Connect the power cables to the electronics module.
Make sure to use the correct po/-
9
ATTENTION!
Perform the following
steps in the order indi-
cated!
!
11
12
+ -
