4
2) MOUNTING BRACKETS / MOTOR UNIT
The mounting of the engine mounts consists of 3 simple steps
Place the aluminum support on the boom and fix the it by means of the 4 M6 bolts and lower plates
block (fig.1)
Before tightening the bolts, check with a set square that the motor support is at 90 ° with respect to
the boom, this will ensure a perfect parallelism between the elements.
Note:
In order
to position the motor unit on the boom correctly you should have a look at the antenna
diagram on page 8. Depending on your model, you need to know that the two external motor units of the
antenna (any model) will always have to be placed at the boom ends, with the cable facing towards the
center of the boom (as shown in the pictures), so no measurements needs to be verified.
Fig.1
Fig.2
Fig.3
Place the lower ABS collars in correspondence of the outer holes of the
support (fig.2)
Insert the rubber sleeves on the motor unit and tighten the internal clamp
(fig. 3)
Place the motor unit onto the support (Figure 4) and place the upper ABS
collars (fig.5)
Insert the M6 x 110mm bolts and tighten them.
Figure A shows the correct position of the motor unit with respect to the
boom.
Fig.A
Fig.4
Fig.5
Fig.6
Note:
To tighten the screws, apply to the list below
Содержание Ultra Beam YAGI 2
Страница 1: ...1 MANUAL STANDARD YAGI 2 3 4 6 ELEMENTS 6 20m Rev 1 10 ...
Страница 10: ...10 Driver 1 Driver 2 ...
