STOPPING THE ENGINE
1) At first set the speed governor lever at low speed position before stopping the engine, and the
run the engine at no-load for three minutes.
2) Set the speed governor lever at “stop” position. Decrease the load gradually when stopping
the engine. Sudden stop of engine will cause abnormal increasement of temperature. Do not
stop engine with decompression lever.
3) Set the fuel cock at “S” (Stop position).
4) If the engine possesses motor type starter, turn the start key switch to “off” position.
5) Pull out the recoil handle slowly until pressure is felt by your hand (that means at the point of
compression stroke, where the intake and exhaust valves are closed) and then let the handle
back to its natural position so that it can prevent rust when the engine is not used.
NOTE: Only after stopping the engine you can pull the recoil handle, otherwise the engine may
be damaged.
© by WilTec Wildanger Technik GmbH
Seite 17
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
