ELECTRICAL CIRCUIT DIAGRAM
TROUBLESHOOTING
If your heater does not work, please follow the instructions below:
Make sure that your circuit breaker or fuse is working properly.
Make sure that the heater is connected to the mains and that the socket is working properly.
If the ON/OFF switch in the ON position is not illuminated, send the heater directly to the service
center for repair.
NOTE: IF YOU HAVE A PROBLEM WITH YOUR HEATING, PLEASE REFER TO THE INFORMA-
TION IN THE USER MANUAL. PLEASE DO NOT TRY TO OPEN OR REPAIR THE HEATER
YOURSELF. THIS WILL VOID THE WARRANTY AND COULD RESULT IN DAMAGE OR INJURY.
IF THE PROBLEM PERSISTS, PLEASE CONTACT THE DEALER.
CLEANING AND STORAGE
Before cleaning your heater, turn the heater off and let it cool down. Disconnect the power to the appli -
ance. The housing can be wiped with a damp cloth and then dried. Do not use abrasive cleaners or
furniture polishes as these may damage the surface. To remove the heater from the wall for cleaning
or renovation, open the screw cap and remove the screws from the wall.
For short-term storage, simply pull out the plug. For long-term storage, you can remove the heater
from the wall or cover it with a suitable material.
© by WilTec Wildanger Technik GmbH
Seite 18
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
