PLEASE RETAIN THESE INSTRUCTIONS.
Instructions for unpacking and fixing to the wall
Unpack the package and find the heater together with the accessory pack.
1. Mark the positions of the four holes on the wall. (The heater must be installed 0.2 m - 1.5 m above
the floor and 1.0 m below the ceiling).
2. Drill the holes from the accessory pack using the drill attachment.
3. Fit the extension tube (the side with arrows should be upside down) into the holes and fix it with
the screws (ST4 * 45mm).
4. Mount the plastic fasteners (side with arrows should be upside down) to the four holes of the panel
radiator and tighten with the screws (M5 * 8mm).
5. Place the panel heater with the plastic fasteners in the extension pipes and tighten it with screws
(ST3 * 12mm) on the sides.
6. To uninstall the unit from the wall, use a screwdriver to loosen only the screws (ST3 * 12mm) that
lock the plastic fasteners and extension tubes and then remove them.
7. Make sure that the distance between the bottom of the heater and the floor is not less than 20cm
when the heater is installed.
© by WilTec Wildanger Technik GmbH
Seite 16
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
