WilTec 62557, Руководство по эксплуатации

Страница: 5 / 6

© by WilTec Wildanger Technik GmbH Item 62557 Page 5
http://www.WilTec.de
http://www.aoyue.eu 05 2021 -1
http://www.teichtip.de
•
Allow the blade to cool down before touching it after use in order to avoid burns.
•
When using the device make sure to maintain an adequate cutting speed and operating tem-
perature as overheating might cause damage to the device and its accessories.
•
Release the trigger for 1 s after 30 s of operation time.
Technical specifications
Output (W)* 100 150 200 250
Voltage (V) 230
Frequency (
㎐
) 50
Blade temperature (
℃
) up to 600 (after 5
–8 s)
Cable length (m) 3
Blade length (
㎜
)* 100 150 200 250
Additional accessories Hex key / copper brush
* Both the output and the blade length depend on the model and type of your device.
Blade installation
1. Use the hex key included in the scope of delivery in order to loosen the screw of the copper
fastener.
2. Insert the blade into the fastener and fasten the screw. Make thereby sure that there is enough
contact for the blade to function properly.
3. Reverse the process in order to remove the blade. It is thereby essential to allow the device to
cool down properly before removing or exchanging the blade in order to avoid burns.