Figure 2: Side view of the dies included
1. Select the appropriate die for the work to be performed.
2. Place spacers
(50),
dies and retaining nuts
(52)
on the input and output shafts
(47, 53).
Tighten the retaining nuts with the wrench
(59).
3. Adjust the position of the upper die according to the thickness of the workpiece using the ad-
justment handle
(60).
4. Adjust the horizontal position of the upper punch by turning the adjusting nut
(27).
5. Set the length stops
(10, 15)
or the stop plate
(14)
to the required size. The required size is
the distance that the shape will have from the edge of the metal. Use the length stops for
sheets and the stop plate for cylinders. The length stops can be precisely adjusted with the
wing nuts
(13).
6. Insert the metal between the dies and slowly rotate the crank arm
(9).
Check the workpiece. It
may be necessary to refine the settings made in steps 3 and 4 again. Repeat steps 3 and 4
until the correct shape has been formed.
Maintaining (s. Fig. 3)
Lubricating
1. All exposed iron surfaces should be coated with light oil to prevent rust.
2. The setting block
(35)
should be greased.
3. Oil the drive shaft
(53)
monthly through the oil connections
(17, 62).
Troubleshooting
Problem
Possible cause
Possible solution
Dies cut through metal
Dies have a too small distance
to each other.
Adjust the position of the dies with the
adjusting handle.
Dies do not shape cor-
rectly
1. Dies incorrectly adjusted
1. Adjust the position of the dies with
the adjusting nut.
2. Loose winged screw
(36)
2. Re-tighten the winged screw.
3. Material worked on too thick
3. Do not esceed the 0.8 mm max.
metal sheet thickness (s. chart).
Crank arm difficult to be
turned
1. Loose or incorrectly posi-
tioned setting block
(35)
1. Adjust the adjusting nut
(21)
and fix it
by tightening the lock nuts
(20).
Un-
tighten the knob
(22)
and adjust the po-
sition of the setting block
(35)
by turn-
ing the adjusting screw
(33),
re-tighten
the knob
(22).
2. Uncorrect lubricating
2. Lubricate correctly (s. “Lubricating”).
© by WilTec Wildanger Technik GmbH
Item 62053
Page 6
http://www.WilTec.de
http://www.aoyue.eu
03 2021
-1