Unpacking
Check the parts delivered immediately upon receipt for possible damage and lacks. Refer to Figs. 1
and 3. In case of the device being damaged or parts missing, the device should not be operated until
the parts have been replaced.
Figure 1
№ Name
№ Name
A
Base assembly group
G
Set of milling dies
B
Hand crank assembly group
H
Set of burring tools
C
Adjusting handle assembly group
I
Set of large rollers
D
Screw wrench
J
Set of flanging dies
E
Spacer (2×)
K
Set of crimping dies
F
Set of small rollers
Important!
The beading machine and dies are coated with a protective film. Remove the coating to
ensure proper fit and operation. The coating can easily be cleaned with a mild solvent, e. g. mineral
spirit, and a soft cloth. Avoid getting cleaning solution on paint or rubber/plastic parts. Solvents can
damage these surfaces. Use soap and water to clean coloured parts or plastic/rubber parts. After
cleaning, cover all exposed surfaces with a light layer of oil.
Warning!
Do not use flammable detergents to avoid a possible fire hazard.
© by WilTec Wildanger Technik GmbH
Item 62053
Page 4
http://www.WilTec.de
http://www.aoyue.eu
03 2021
-1