Introduction
Thank you for purchasing this quality product.
To minimize the risk of injury we urge that our cli-
ents take some basic safety precautions when using this device. Please read the operation in-
structions carefully and make sure you have understood its content.
Keep these operation instructions safe.
Safety instructions
•
Read the instructions thoroughly and familiarize yourself with the application control, the ap-
plication procedure and the warnings.
•
The device should not be exposed to moisture. Do not use this device in damp or wet loca-
tions. Keep away from rain.
•
Keep the working area clean and well-lit. A untidy or dark working area increases the risk of
accidents.
•
Keep children away from the work area. Children must be supervised to ensure that they do
not play with the appliance. Keep unused tools out of the reach of children and untrained per-
sons.
•
Do not operate this device if you are under the influence of alcohol or drugs or if you are tired.
•
Always take care of selfprotection while working with this item. The use of ANSI approved
safety goggles (everyday glasses are not safety goggles), non-slip safety shoes, safety helmet
and ear protection is recommended.
•
Stay concentrated and do not allow distractions during bending.
•
Do not attempt to operate this device near flammable materials or combustibles. Failure to do
so may result in serious injury.
•
Do not wear loose clothing, avoid long hair during bending and take off your jewellery. Loose
clothing, long hair, jewellery, etc., may pose a potential danger when operating the device,
take care of your safety.
•
Always check the unit before use. Make sure that all parts are in good condition and work
smoothly. If in doubt, do not use the item.
•
Make sure that the bottle jack stands on a level and firm surface and that it cannot slip during
use.
•
Keep your hands away from moving parts.
•
Use the correct tool for your application. Never exceed the rated load of the item.
•
Never open screw connections under pressure/load.
•
Before operating your pipe bender, make sure that no air is trapped in the pipe bender. Push
the ram down until it fully retracts into the jack. This should displace all air.
Main features
This pipe bending machine is designed to bend water pipes, rigid pipes and high wall thickness gal-
vanized pipes used in commercial applications and other similar types of pipes. When bending thin-
walled pipes (pipe or line), fill the pipe with sand and close the ends before bending.
Capacity (t)
Module size
(inch)
Net weight (kg) Dimensions (mm)
Degree of Bend
16 tons
½, ¾, 1, 1¼, 1½,
2, 2½, 3
55
680×610×190
Up to 90°
© by WilTec Wildanger Technik GmbH
Item 61490, 51840
Page 3
http://www.WilTec.de
http://www.aoyue.eu
01 2021-1