WilTec 61076, Руководство по эксплуатации

Страница: 7 / 10

© by WilTec Wildanger Technik GmbH Item 61076 Page 7
http://www.WilTec.de
http://www.aoyue.eu 06 2021 -1
http://www.teichtip.de
Other important safety notes
Thoroughly read the operating manual and keep it for future reference.
•
The reciprocating saw may only be connected to a domestic socket with 230
–240 V tension.
•
Never leave children unattended when handling electric devices!
•
When children are present, you should work especially careful.
•
Place the reciprocating saw in a safe area, out of reach of children, after finishing the work.
•
The device and the supply line must never touch hot surfaces or open fires.
•
Before changing the saw blade, the electricity plug needs to be disconnected.
•
After every use, but in any case before cleaning, please unplug the electricity plug from the
socket. The same applies to any form of malfunction, which might occur during operation.
•
The device must never come into contact with water or other liquids, it may only be wiped
with a dry cloth or soft brush.
•
When working with the reciprocating saw, we recommend to wear safety glasses for safety
reasons.
•
Before connecting the device to the electricity supply, please ensure that it is switched off.
Operating manual for the electric reciprocating saw
Use
The reciprocating saw can be used for wood, plastic, plasterboards, and metals. Ensure that the mains
voltage complies with the stated voltage of the type label of the device.
Changing the saw blade
Before every work on the device and when chang-
ing the saw blade, turn the saw off and unplug the
plug from the socket. Turn the ring
(a) at the saw
blade intake (6), as seen in picture 2, until the saw
blade (b) can be pushed into the slot of the saw
blade intake (6). Let go of the ring (a), it should go
back into its starting position. If this is not the case,
try to place the ring
(a) back into its position. Now,
check whether the saw blade stays in the intake by
carefully pulling it.
Turning the device on/off
On: Push the switch, then the self-blocking button
and release the switch.
Off: Push the switch and release it again.
Speed setting
Preselect the rotation speed with the wheel disk:
= increase speed
= decrease speed
The more the button is turned, the higher the
rotation speed. The speed can be adjusted
stepless, to the required speed.