WilTec 51743, Руководство по эксплуатации

Страница: 6 / 6

© by WilTec Wildanger Technik GmbH Item 51743 Page 6
http://www.WilTec.de
http://www.aoyue.eu 06 2021 -1
http://www.teichtip.de
6. Pull the tire onto the neutral rim and let it swing out. The lightest place is now up again (see
Fig. 3). Mark this spot in a different colour.
5. Now remove the applied balancing weight (step 5). With a little bit of luck, the unbalance of the
rim without tires and the rim with tires is annulled. If this is not the case, turn the rim so that the
two marked points are as shown in Fig. 4. Now the complete wheel is balanced. Normally, you
only need one of the two weights. The weight must be applied until the complete wheel remains
in the rest position. When doing so, be careful to use as little weight as possible, the weight
should be evenly distributed on both sides of the rim. If a total weight of more than 50 g is
required, then you should reclaim the tyre.
Important notice:
The reprint or reproduction, even of excerpts, and any commercial use, even in part, of this instruction
manual require the written permission of WilTec Wildanger Technik GmbH.