© by WilTec Wildanger Technik GmbH
Item 51743
Page 3
06 2021
-1
Introduction
Thank you for purchasing this quality product.
To minimize the risk of injury we urge that our clients
take some basic safety precautions when using this device. Please read the operation instruc-
tions carefully and make sure you have understood its content.
Keep these operation instructions safe.
Description
The professional balancer is a great help in the correction of unbalance. With the use of gravity, it can
find the focus of any tire and is suitable for almost all motorcycles. With the robust steel construction,
this balancing machine guarantees a long-term use.
Safety instructions/warnings
The owner and/or user must have read and understood the operating instructions of the device before
using it. Personnel should be cautious, competent, trained and qualified in the safe handling of the
working equipment used when working on engines and their components. Warnings should be read and
understood.
•
Be familiar with the application control, the application process and the warnings.
•
Ensure that all connectors are secure.
•
Make sure you know the contents of the instructions for use.
•
This device is not intended to be used by persons (including children) with reduced physical,
sensory or mental abilities or persons who do not have the appropriate experience or
knowledge, unless they are supervised by a person responsible for their safety or have previ-
ously been instructed by such to use the equipment.
•
Children must be supervised to ensure that they do not play with the appliance.
•
Immediately report to your supervisor or workshop as soon as something unforeseen happens.
•
Always pay attention to the optimal lighting of the workplace.
•
Be sure to wear solid footwear.
•
Use a hairnet for long hair.
•
Wear tight clothing.
•
Take off jewellery (rings, earrings, watches, etc.).
•
Be careful not to wear loose straps or belts.
Assembling the wheel balancer
1. Place the stands with the bearings inward on the base. Position the stands over the inner or
outer holes of the stand, depending on the tyre size you want to balance. Fasten the stands as
shown with the 2×8 mm socket screws on the base. You need a 6 mm hex wrench and a 13 mm
wrench.
2. Screw a nut on each foot and carefully tighten it. Do not over-tighten the screw.
3. Change the height of the feet so that the balancing stand is straight. Check the stand with a
water tank.
4. When the balance stands straight, tighten the nuts of the feet.
