For free U.S. based technical support or to order accessory items please call
800-204-4104 or visit www.wilsonelectronics.com
4
For free U.S. based technical support or to order accessory items please call
800-204-4104 or visit www.wilsonelectronics.com
Sleek™ Power connector.
Connect to Wilson’s power supply
Antenna
connection
Accessory USB Power port
3. Attach the Sleek™ to the Bracket
Once you have installed the bracket in the desired location, and waited 24 hours for adhesive to cure, attach
the Sleek™ by aligning the rectangular hole on its back with the tab on the mount bracket, grasping the sides
of the Sleek™, and sliding it downward approximately ¼ inch into place.
Adjusting the Sleek
TM
Arms
Included with your Sleek
are various sized arms, which will provide you with multiple options
to customize the SleekTM to fit your phone.
1. Change arms
Gently grab the arm and lift
upward until the arm breaks
free from the Sleek™.
2. Reposition arms
Position the arm above a different slot on
the Sleek
TM
(indicated by the yellow in the
drawing). Gently slide the arm down until
the arm is firmly in place.
Power up the Wilson Sleek™
IMPORTANT: Make sure the outside antenna cable is
connected before powering up the Sleek
™
.
Connect the mini-USB plug on the power cable to the Sleek’s
mini USB port located on the bottom of the Sleek
™
and insert
the adapter into the cigarette lighter outlet of your vehicle.
The Sleek
™
may remain on all the time. However, leaving the
Sleek
™
on in a vehicle when it is not running can discharge the
battery in a day or two.
Note: The 12V DC power source on many vehicles is shut off
with the ignition key.
WARNING:
Use only the supplied Wilson power supply.
NOTE: The cell phone must be placed in the Sleek
™
to work properly. Use a Bluetooth or wired
hands free device.
4. Attach the Outside Antenna cable to the Sleek
Attach the cable from the outside antenna to the antenna connector on
the Sleek.
