Wilson Electronics 460061, Руководство по установке

Страница: 14 / 24

12
FIXING BLINKING OR RED LIGHT ISSUES
This section is only applicable if the Booster is red or blinking red and you are not
experiencing the desired signal boost.
■ Unplug the booster’s power supply .
■ Relocate the inside and outside antenna further from each other . The objective is
to increase the separation distance between them, so that they will not create this
feedback condition discussed before .
■ Plug power supply back in and ensure switch is in ON position .
■ Monitor the indicator light on your booster . If, after a few seconds of ‘power on’,
a solid or blinking red light appears, repeat prior steps . Increase the separation
distance until the condition is corrected and/or desired coverage area is achieved .
Note: Horizontal separation of the two antennas typically requires a shorter
separation distance than vertical separation .
If you are having any difficulties while testing or installing your Booster, contact our
weBoost Customer Support team for assistance (866 .294 .1660) .
Troubleshooting