WILSON AUDIO Sasha WP, Руководство пользователя

Страница: 39 / 72

39
W i l s o n A u d i o S p e c i a l t i e s
S e c t i o n 4 . 1 – S p i k i n g t h e S a s h a W / P
39
Section 4.1 – Spiking the Sasha W/P
Your dealer is trained in the art and science of the Wilson Audio Setup Procedure
(WASP) outlined in Section 1.1. Before the spike/diode assemblies are attached to the
bottom of Sasha W/P, the set up and fine tuning of your loudspeaker should be com-
pleted. Before spiking Sasha W/P, use masking tape to carefully mark their location.
Woofer Module Spikes
Included with Sasha W/P are two sets of Woofer Module spikes, which provide
acoustical isolation as well as optimal height placement for your speakers. There are
three ways of assembling the spikes (without spacers, or with one or two spacers).
Your choice will depend on your listening room and personal tastes. Wilson generally
recommends no spacers, for simplicity and rigidity. However, the addition of spacers
changes the driver-to-floor dimension and can sometimes be used to reduce an objec-
tionable upper-bass/lower mid-range coloration in the sound.
Spike/Diode Assembly
1. Locate the spike assembly. On the spike, move the nut to about two
threads from the point. This will allow for greater movement when level-
ing the loudspeaker system.
2. Screw the spikes into the diode until the nut is against the diode. Be
careful that the nut does not turn while inserting and threading spikes
into the diode.
Note: Do not tighten these assembled spikes. You will need to unscrew them when
you level the Sasha W/P. This will ensure that if for any reason you have to remove
Sasha W/P spikes, you will be able to withdraw the set screw using the supplied Allen
wrench.
3. Screw the set screw into the diode until it meets the spike (see Figure 7).
4. Locate either the 1.5 inch or 2 inch (See Figure 7) set screw. The 1.5