Wilo Rexa MINI3-S, Инструкция по установке и эксплуатации

Страница: 5 / 16

en
Installation and operating instructions • Wilo-Rexa MINI3-S • Ed.01/2022-03 5
1.5 Pump with macerator
The pump is equipped with a macerator on the
suction port. The macerator has rotating and
fixed blades. The blades are accessible from the
outside.
WARNING
Risk of injury on the macerator!
The blades are extremely sharp. There is a danger of
cuts and similar injuries!
• Never touch the macerator!
• Always carry the product by the handle!
• Always wear protective gloves (uvex phynomic
wet) when using the product!
1.6 Fluids hazardous to health
In stagnant water (e.g. pump sump, soakaway,
etc.) germs which are hazardous to health can
form. There is a danger of bacterial infections!
• Clean and disinfect the product thoroughly
after removal!
• Inform all persons about the pumped fluid and
the danger it poses!
1.7 Personal protective equipment
The aforementioned branded products consti-
tute non-binding suggestions. Similar products
from other brands can also be used. WILO SE
does not assume any liability for the aforemen-
tioned products.
Protective equipment: Transport, installation,
removal and maintenance
• Safety shoes: uvex 1 sport S1
• Protective gloves (EN 388): uvex phynomic
wet
Protective equipment: Cleaning work
• Protective gloves (EN ISO 374-1): uvex pro-
fapren CF33
• Safety goggles (EN 166): uvex skyguard NT
• Breathing protection mask (EN 149): Half
mask 3M series 6000 with filter 6055 A2
1.8 Transport and storage
• Wear protective equipment!
• Always carry the product by the handle!
• Clean product and disinfect if necessary!
–
Dirt fosters the formation of germs.
–
Encrustations may lead to the impeller be-
coming blocked.
1.9 Installation
• Wear protective equipment!
• Do not install damaged or defective products.
• If there is a risk of germ formation, observe
the following points:
–
Ensure sufficient air exchange.
–
Wear a breathing protection mask e.g. Half
mask 3M series 6000 with filter 6055 A2
1.10 Electrical connection
• Do not connect products with a damaged
connection cable! Have the connection cable
replaced by a qualified electrician or the cus-
tomer service.
• Mains connection with correctly installed pro-
tective earth conductor.
• Install the residual-current device (RCD) with
30 mA.
• Fuse protection at mains connection: max.
16 A.
• Product without plug: Electrical connection
must be carried out by a qualified electrician!
1.11 During operation
• The pumping of highly inflammable and ex-
plosive fluids (petrol, paraffin, etc.) in their
pure form is strictly prohibited!
• If persons come into contact with the
pumped fluid (accessible basins*), do not
commission the product.
*Definition of “accessible basins”
Installation sites that can be walked on and dir-
ectly accessed without tools (examples below):
• Garden ponds
• Swimming ponds
• Cesspools
NOTICE! The specifications applicable to
swimming pools also apply to accessible
basins.
1.12 Removal
• Wear protective equipment!
• Product without plug: Have the connection
cable disconnected from the mains by a qual-
ified electrician.