Wilo HiSewlift 3 Series, Инструкция по установке и эксплуатации

Страница: 19 / 32

10 Faults, causes and remedies
WARNING! Risk of electric shock!
Before any work on the system, DE-ENERGISE the unit by disconnecting
the electrical supply to the system, and prevent unauthorised restarting.
The indicator light being off does not mean that the pump is de-energised.
If you cannot remedy the fault, please contact Wilo customer service.
30
English
Faults Causes Remedies
The motor will not start Device is not plugged in Plug in the device
Faulty power supply Check the power supply
Problem with motor or
control system Contact an approved repair
technician
The motor is running
with a rattling noise or is
humming but not running Motor blocked by a foreign
object Remove the foreign object
Problem with motor or
control system Contact an approved repair
technician
The device keeps stopping
and starting The connected sanitary
devices are leaking Check the upstream installations
The non-return valve is
leaking Clean or replace the non-return
valve.
The motor is running
correctly but does not
stop or runs for a very
long time The height or length of the
drain is too great (friction
loss) Review the installation
Hydraulic problem (clogging) Contact an approved repair
technician
The device has stopped The device was running for
too long (high temperature
cut-out) Wait for reset, then contact an
approved repair technician if
necessary
The motor is running
jerkily and the water in
the toilet bowl is going
down slowly The vent in the cover is
blocked up Unblock the vent hole
Motor problem Contact an approved repair
technician
Turbid water flowing
back into the shower
(device with lateral inlets) Shower connected too low
relative to the comminutor Review the installation
Flaps on lateral inlets clogged Clean the flaps, then contact
an approved repair technician if
necessary
09/2014