WH-2800 SERIES
PATIENT CARE UNITS
INSTALLATION & OPERATION MANUAL
PAGE
10
© Rev.
9/2022
1.800.428.4065
TOLL FREE
| www.willoughby-ind.com
INSTALLATION INSTRUCTIONS (CONT.)
Step 6:
Install the Solid Surface Lavatory Top to the Cabinet
1.)
Install the drain assembly inside the lavatory top.
2.)
Apply a bead of silicone caulk around the outer top edge of the cabinet and between the
lavatory top and the wall.
3.)
Set the lavatory top in place on the cabinet making sure the back is flush with the wall. Clean
up excess caulk around the countertop edge.
Step 5:
Install the Toilet and Waste Connections
1.)
Slide toilet into position over the Z-clip installed in Step 2.
2.)
Connect the toilet to the floor/wall waste outlet with an appropriate gasket. Square the toilet to
the back wall.
3.)
Level and support the toilet solidly at the four corners using shims, if needed
(shims supplied by installer).
4.) Secure the toilet in place with appropriate hardware.
NOTE: If the waste outlet is through the back, use a no-hub type connector
(available as an option).
5.)
On WH-2800 models with a back waste connection, tighten the connector clamps at this time.
