LX4RT SERIES INSTALLATION INSTRUCTIONS
H.E. Williams, Inc. Car thage, Missouri w w w.hew.com 417-35 8 - 4 0 65
Page 4 of 4
PN 49090154
TRIMLESS SERIES (LX4RTL FLANGELESS TRIM VERSION)
STEP 4: INSTALL FLANGELESS TRIM
A. Install and center double mitered end trim into ends of
fixture.
5.9” end trim
Side trim
1.
For row-mount application, cut the double mitered side trim,
supplied with the feeder fixture, in the middle between clips
that are approximately 4” apart. Install one half of the trim into
the fixture at the start of the row and the other half of the trim
into the fixture at the end of the row. Position tight against
the double mitered end trim already installed.
Length varies by application
4” approx.
2ft max
between clips
Cut on centerline
3/4” approx.
(both ends)
DBL miter - side trim
2.
Install 8ft side trims between the previous trims installed.
Cut the last 8ft side trim to fit square with the half piece of
mitered side trim at the end.
DO NOT RECUT THE MITERED
ENDS.
Cut to length
as required
Half piece of
mitered side trim
(both ends)
8ft side trim
STEP 5: INSTALL FILM MASKING (SUPPLIED WITH
FIXTURE)
NOTE:
Adhesive on masking film is not permanent and can be
reapplied.
A. Adjust length of mask by cutting mid-section only as
required.
Use factory cut ends to mask tight with ends of
fixture.
Factory cut end
Cut from center as required
1.
Allow for 1”-2” overlap of masking when installed.
1”-2” overlap
2.
Remove adhesive liner from one edge of masking.
3.
Apply edge of mask to fixture housing inside of trim.
Mask
Factory
cut end
4.
Remove adhesive liner from second edge of masking.
5.
Apply second edge of mask to fixture housing.
6.
Continue masking fixture row. Overlap joints by 1”- 2” as
shown above.
STEP 6: APPLY SEAM TREATMENT
A. Tape and mud trim flange to ceiling material.
Apply tape to
cover half of trim.
NOTE:
USE A NON MOISTURE ABSORBENT TAPE, SUCH AS
FIBERGLASS MESH TAPE, TO AVOID SEAM POPPING ON THE
TRIM.
Tape and mud
trim flange
Tape over
half of trim
STEP 7: FINISH CEILING TREATMENT
Including texture and paint as required.
STEP 8: INSTALL LENSES
(See Page 3, Step 8)
