6
PPA R38 FM Receiver
Basic Settings
The Basic Setup functions allow the user to change
the most frequently used settings easily. The user
can change the receiving channel (or frequency),
and the volume level. Before performing these
steps, plug in earphones, headphones, or a
neckloop into the headphone jack on the receiver.
1.
POWER UP
: Turn on the receiver by pushing and
holding the power button for 3 seconds. The receiver will
start up and show the following three screens. The last
screen is the Main or “Home” screen.
2.
CHANNEL
: Next, set the receiving channel. Push the
menu button once to show the channel set screen.
Push either arrow button to
step
to one of the 17
channels (above) -or- push-and-hold either arrow
button to
seek
to the next active channel (below).
The receiver is seeking the next
frequency
, so
channels may appear out of order when seeking.
If no actively-broadcasting channels are found during the
seek, a message is displayed (below). Make sure you are
on the same channel as the transmitter. When finished,
push the menu button once to get back to the home
screen, and go to step 3.
T46 FRONT
LEFT
ARROW
BUTTON
RIGHT
ARROW
BUTTON
MENU
BUTTON
OLED
DISPLAY
A309
figure e: front Controls
A430
VOLUME
LEVEL
BATTERY
LIFE
CHANNEL
(OR FREQ.)
RF SIGNAL STRENGTH SETTINGS LOCKED
figure f: display showing main ”Home” Screen
Controls and display
The top and front controls referred to in this manual, along with an
illustration of the indicators on the main screen, are shown in Figures
D, E and F.
A447
R38 TOP
POWER BUTTON/
LOW BATTERY
INDICATOR
figure d: top Controls
