Audio Connections:
The WMS R11 Receiver can be connected to a microphone input or a
line-level input on your mixer or amplifier.
(1) Line-Level Connections:
Use an appropriate audio cable to connect the WMS R11 Receiver
"Unbalanced Line Output" 1/4" jack to an AUX IN, TAPE IN, or LINE IN
jack on your amplifier or mixer. This connection will result in the lowest
system noise level and leave you an extra Mic Input jack on your mixer
or amplifier. Be sure to use high-quality, shielded cables and avoid
unbalanced cable runs of six feet or longer. Use the "Output Level"
Control on the rear panel of the Receiver to balance the wireless mic
level with your other microphones and to achieve a convenient control
setting on your mixer.
(2) Microphone-Level Connections:
Use a standard microphone cable to connect the WMS R11 Receiver
"Balanced Mic Output" XLR jack to a MIC IN jack on your mixer or
amplifier. If you do not have a microphone cable, you can purchase one
ready-made from an electronics parts store, or you can make one as
shown. Always use shielded cable and XLR connectors.
MIC 1
MIC 2
MIC 3
Tape In
Aux In
MIC INPUTS
LINE INPUTS
Amplifier or Mixer
VHF Wireless Microphone Receiver
Model WMS R11
Balanced
Mic Output
Unbalanced
Line Output
Output Level
Antenna
75 Ohm
Power
120 VAC
50/60 hz
3W
Williams Sound Corp.
Minneapolis, Minnesota, U.S.A.
R11
Receiver
1
2
Mic-Level
Line-Level
XLR
1/4"
1
2
3
1
2
3
Male XLR
Female XLR
2-Wire, Shielded
Cable
16
