20
IR Plus Assistive Listening System
Network Page
The Network Settings page affects settings specific to the server as a whole. The page displays network connectivity settings,
which are typically not needed after initial installation.
Changing a static IP address or subnet will not instantly take place. The changed IP address or subnet will only take affect once
the device is rebooted,. The device will automatically reboot when saving changes to the IP Address settings.
Note: If the IP address or subnet of the device was changed and the device is being rebooted, the website may not be available at
the same URL location� Take note of the network information before rebooting the device�
TTL can be modified if there is a need. The recommended setting for the least latency is 1, but it can be set up to 31. This setting
should not be adjusted without proper consideration for your system setup.
For each channel, the security settings and the multicast information of the channel can be adjusted.
Secure Mode can be enabled or disabled, and a 6-digit PIN number can be assigned. If enabled, users will need to use this PIN to
log on to the audio stream. Users attempting to listen to the stream without the PIN will be unable to do so.
A multicast address can be automatically assigned. If a specific multicast address is required, the device administrator can enter
the desired multicast address. There is no unicast mode of the IR +.
Additional networking information is described in "Network Configuration" on page 14.
