5.
Quick start and step by step examples:
To use your controller, you only need to set 3 parameters: [
HC
], [
Lb
], [
Hb
]. Others are optional.
Tips: Holding the button allows for rapid number adjustments
HC=H
Humidification
The load will be turned on once detected humidity is below
[Lb]
.
The load will be turned off once detected humidity reaches
[Hb]
.
HC=C
Dehumidification
The load will be turned on once detected humidity is over
[Hb]
.
The load will be turned off once detected humidity reaches
[Lb]
.
Example #1
Control a humidifier:
Keep humidity between 70% and 85%.
Parameter value: [
HC = H
] [
Lb = 70
] [
Hb = 85
]
1, Power on the controller
2, Press SET for 3 seconds, release button when you see HC. Press SET once to enter
HC
parameter.
3, Press UP/DOWN to select H
.
Press SET once and go back to menu.
4, Press UP to select
Lb
. Then press SET once to enter
Lb
parameter
5, Press UP/DOWN to specify
70
for
Lb.
Press SET once and go back to menu.
6, Press UP to select
Hb
. Then press SET once to enter
Hb
parameter
8, Press UP/DOWN to specify
85
for
Hb.
9, Press POWER. DONE.
How it works:
Once the detected humidity is below 70%, the controller turns on the humidifier.
Once the detected humidity reaches 85%, the controller turns off the humidifier
.
NOTE: The WH1436H can accurately controls turn-on and turn-off points. However, there might be
overshooting. It’s not the WH1436H's fault. You can consider changing the power of your humidifier to
compensate for the overshooting effect.
Example #2 Control a dehumidifier:
Keep humidity between 35% and 38%. Alarm sounds when the
temperature exceeds 40%.
Parameter: [
HC = C
] [
Lb = 35
] [
Hb = 38
] [
AH = 40
]
1, Power on the controller
2, Press SET for 3 seconds, release button when you see HC. Press SET once to enter
HC
parameter.
3, Press UP/DOWN to select
C
.
Press SET once and go back to menu.
4, Press UP to select
Lb
. Then press SET once to enter
Lb
parameter
5, Press UP/DOWN to specify
35
for
Lb.
Press SET once and go back to menu.
6, Press UP to select
Hb
. Then press SET once to enter
Hb
parameter
7, Press UP/DOWN to specify
38
for
Hb.
Press SET once and go back to menu.
8, Press UP to select
AH
. Then press SET once to enter
AH
parameter
9, Press UP/DOWN to specify
40
for
AH.
10, Press POWER. DONE.
How it works:
Once the detected humidity exceeds 38%, the controller turns on the dehumidifier.
Once the detected humidity reaches 35%, the controller turns off the dehumidifier.
If the dehumidifier is defective and the humidity exceeds 40%, it beeps and displays H and the
detected humidity on the screen.
