Wilks USA RX525i, Руководство по эксплуатации

Страница: 10 / 18

8
This will prevent the detergent from
sliding down and causing streaks. High
pressure rinsing should also progress
from the bottom to top. On particularly
tough stains, it may be necessary to use
a brush with detergents and high
pressure rinsing.
Pre-operation
The following cleaning procedure will
help you to organize your cleaning task,
and ensure that you achieve the most
beneficial results in the shortest amount
of time. Remember to use the
spraying/cleaning techniques previously
listed.
1. Surface Preparation
Before starting a pressure wash
cleaning job, it is important to prepare
the surface that is to be cleaned. This is
done by cleaning the area of furniture,
and making sure that all windows and
doors are closed tight. In addition, you
should make sure that all plants and
trees adjacent to the cleaning area are
protected by a drop cloth. This will
ensure that your plants w
on’t be sprayed
by the detergents.
2. Initial High Pressure Rinse
The next step is to spray the cleaning
surface with water to clear off any dirt or
grime that may have collected on the
surface. This will allow your detergent to
attack the deep down dirt that has worked
its way into the cleaning surface. Before
triggering the gun, adjust the nozzle to a
wide fan pattern and slowly adjust to the
desired spray pattern. This will help you
avoid applying too much concentrated
spray to the surface which could cause
damage.
3. Final Rinse
Start final rinse at bottom and work upward.
Make sure you thoroughly rinse the surface
and that all detergent has been removed.
4. Shutdown
1. be sure all detergent is flushed from
system.
2. Turn off motor.
3. Turn off water supply.
4. After motor and water supply are turned
off, trigger gun to depressurize system.
CAUTION:
NEVER turn water supply off
before turning motor off. Serious damage
could occur to the pump and or motor.
WARNING!
NEVER disconnect high
pressure discharge hose from machine
while
system is pressurized. To
depressurize, turn motor off, turn water
supply off and squeeze gun trigger 2-3
times. 5. After each use, wipe all surfaces of
the pressure washer with a clean, damp
cloth.
5. Storage
Do not store pressure washer outdoors.
Do not store pressure washer where it
might freeze.