Wildfire RAVEL HE F-101 2 Series, Инструкция по эксплуатации

Страница: 10 / 25

10
Remove the protecve covering (if applicable) from the face of the decorave trim. Fit the trim to the appliance the by
placing the two magnets provided in each corner at the top of the trim. Then adjust the lower two magnec screws to
provide the correct posion for the trim.
Care should be taken that the magnet does not come into contact with any
moving parts of the slide control lever mechanism. This advice should also be passed onto the consumer to ensure that
they are aware of magnet posioning. A service call due to incorrect placement of magnets which cause difficulty in
lighng the appliance will result in a callout charge being made.
Posion the fret in front of the appliance ensuring that it meets the following requirements.
THE INSTALLER MUST INFORM THE CUSTOMER OF THE FOLLOWING TO COMPLETE THE INSTALLATION
Demonstrate the lighng of the appliance and the controls to control the heat se@ngs. Demonstrate how to turn the fire
off.
Demonstrate the removal of the trim and fret and how to reinstall correctly.
Discuss the removal and reinstallaon of the glass and the ceramics. Explain how they should be cleaned and make the
customer aware of the health and safety warning detailed later in these instrucons.
Explain to the customer that the ceramics are fragile and must be treated with great care, explain that the ceramics are
not covered by the warranty because of their fragility. Also explain that small hairline cracks will appear in the surface of
the ceramics due to heat expansion and contracon—this is perfectly normal.
During the first several hours of use an odour will be experienced—this is normal and is the starch used in the
manufacturing of the ceramic fuel bed. This odour is non toxic and will eventually disappear with use.
Advise the customer that ALL glass fronted gas appliances will leave condensaon on the inside face of the glass when first
lit—this is perfectly normal and is a result of the water vapour present in the combuson products hi@ng the cold glass
surface. This condensate will disappear over the next minute or so. It is also important to advise the customer that this
condensate will carry with it any
impuri8es in the air and will therefore, with use, leave a slight grey condensa8on mark
on the inside of the glass. We advise that this is cleaned off maybe 2 to 3 mes a year, dependant on use.
Advise that no rubbish should be thrown onto the appliance and that the appliance should be cleaned regularly.
A vacuum cleaner can be used but it is important that the appliance is turned off and allowed to cool before undertaking
this procedure. See the separate secon regarding cleaning the ceramics.
Advise the customer that the appliance should be serviced annually by a gas safe engineer to ensure the safety and
integrity of the appliance.
Advise the customer that the appliance has a naked flame and therefore it is essenal that a suitable fireguard be used for
the protecon of the elderly, infirm and young children. This fireguard should conform to BS8423 : 2002 (Fireguards or use
with Gas Heang Appliances).
These instrucons
must be handed over to the customer once installaon is complete.
COMPLETING THE INSTALLATION OF THE APPLIANCE