Wildfire EffectsMaster EM-22L, Руководство по эксплуатации

Страница: 5 / 18

Setup & Operation
Unpacking
Unpack the fixture and carefully inspect it for any signs of physical damage. Report any damage to Wildfire or
your local distributor immediately. Included with each unit should be the following items:
1. Power Cord
2. PowerCON power output cable connector (used to power link additional fixtures)
3. Operation Manual
4. Warranty Card
Optional Accessories:
Twenty Clamp – These clamps when attached to both of the fixtures adjustable mounting brackets allows you
to mount the fixture to a standard 2” pipe truss. Contact Wildfire or your local distributor for pricing.
Safety Cable - This cable is to be used when installing the fixture on a pipe truss with the Twenty Clamps. It
attaches to the adjustable brackets on the sides of the fixture securing it from falling if the clamp is not tightened
properly. Contact Wildfire or your local distributor for pricing.
Floor Mount Kit - This aluminum stand set enables you to mount your fixture on the floor for footlight
applications. Contact Wildfire or your local distributor for pricing.
T-Bar Ceiling Mount
- These brackets enable you to mount your Effects Master fixture to the t-bars in a
standard drop ceiling. Contact Wildfire or your local distributor for pricing.
Setup
Connect the blue PowerCON connector on the power cord to the blue PowerCON AC Input receptacle on the
fixture. The fixture is also provided with a gray PowerCON AC Output receptacle, enabling you to interconnect
power between fixtures.
Do not interconnect more than ten model EM-44L, fifteen model EM-42L or 30 EM-
22L fixtures in a single chain.
Plug the fixture into the appropriate properly grounded power source. If you are controlling the unit with a
lighting control board you will need to make sure it is plugged into a non-dim circuit.
Do not at any time plug
the fixture into a dimmable circuit, doing so will damage the LED lamps in the fixture and void the
warranty.
Operation
To turn the fixture on switch the rocker switch on the side of fixture to the ON position. Unplug the fixture from
the AC power outlet during prolonged periods of non-operation.
5