wiking Luma 1, Инструкция по установке и эксплуатации

Страница: 20 / 24

Page 20 of 24 pages
Insulation
The efficient, but porous insulation of the combustion chamber may, in time, be worn and da -
maged. Cracks in the insulation are irrelevant to the efficiency of the stove. A crack in the back
plate can cause secondary air to become incorrectly distributed in the combustion chamber,
and it should therefore be replaced. However, it should be replaced, if there are actual holes
due to parts of the lining falling off or when, due to wear and tear, it has been reduced to less
than half its original thickness.
WIKING
®
Automatic™
The spring in the automatism should be controlled at least once every second year.
(Drawing G): Lift the top plate off the stove. Lift the rear plate of the stove. On a cold stove, the
starting point of the feeler is controlled. The starting point on a cold stove is about 10
0
above
horizontal. It should feel easy going and bouncy when you push it, no matter if the stove is cold
or hot. Mount the rear plate and the top plate again.
Door/glass
A sooty glass door can easily be cleaned with a piece of moist kitchen roll dipped in ash. Go
about it in vertical movements (up and down). Follow up with a dry piece of kitchen roll. You
should also ensure that air gaps in the door frame are free of ash and soot particles.
Seals
Check frequently to ensure that seals in the door and ash pan are intact and not brittle. Failing
this, they should be replaced. Use original seals only.
Surface
Usually, it is not necessary to any treatment to the painted surfaces of the wood-burning stove.
Any damage to the paint may, however, be remedied with spray paint, which can be bought
from your stove retailer.
Guarantee
The guarantee does not cover damage due to insufficient maintenance!