WIKA CPG2300 Series, Руководство по эксплуатации

Страница: 23 / 44

Operating Instructions CPG2300 Series 23
Portable Digital Pressure Gauge
CPG2300 Series
6.3.5 Units Screens
Pressure units must not be changed when using the null feature.
There are three units screens that allow selection of the most common pressure units:
PSI InHg 0c
InHg 60f InH20 4c
InH20 20c mBAR
BAR more
mmHg 0c cmHg 0c
Pa hPa
kPa mPa
ks/cm^2 more
cmH20 4c cmH20 20c
MSW User
Set User more
The pressure unit of the active sensor is selected by highlighting the desired unit and
pressing the
♦
(enter) key. To advance to the next units screen, select “more”. The last
units screen allows selection and entry of a special “User” unit. The User unit has a
configurable conversion factor that converts from PSI to the desired value. To enter the
conversion factor, select “Set User” on the last units screen to display:
Set User Units A
+1.1
Enter to Continue
Use the left and right arrow keys to move the cursor under the digit to change and the
up and down arrow keys to increment the digit. The conversion factor can be set from
-1.6 to -1.00000e-6 and +1.00000e-6 to +1.6. Press the
♦
(enter) key
to store the conversion factor. To apply the “user” conversion factor, the units “User”
must be selected for the active sensor.
For the remote programmable pressure units list and information,
see “User Programmable Pressure Units List” in the Remote
Operation section of this manual.