5 Managing Switch
50
Wieland Electric GmbH | BA001047 (Rev. A) | 06/2018
To access this page, click L2 Switching > Link Aggregation > LAG Port Settings.
The following table describes the items in the previous figure.
Item
Description
LAG Select
Click the drop-down menu to select a predefined LAG trunk definition: LAG 1-8.
Enabled
Click the radio button to enable or disable the LAG Port.
Speed
Click the drop-down menu to select the port speed: Auto, Auto-10M, Auto-100M,
Auto-10/100M, 10M or 100M.
Flow Control
Click the radio button to enable or disable the Flow Control for the LAG Port.
Apply
Click Apply to save the values and update the screen.
The ensuing table for LAG Port Status settings are informational only: LAG, Description, Port Type, Enable
State, Link Status, Speed, Duplex, FlowCtrl Config and FlowCtrl Status.
5.7.3.4
LACP Priority Settings
The LACP Priority Settings page allows you to configure the system priority for LACP.
To access this page, click L2 Switching > Link Aggregation > LACP Priority Settings.
The following table describes the items in the previous figure.
Item
Description
System Priority
Enter the value (1-65535) to designate the LACP system priority.
Apply
Click Apply to save the values and update the screen.
The ensuing table for LACP Information settings are informational only: System Priority.
Figure 5.19 L2 Switching > Link Aggregation > LAG Port Settings
Figure 5.20 L2 Switching > Link Aggregation > LACP Priority Settings
