Safety notes
Wieland Electric GmbH | BA001269 | 09/2021 (Rev. A)
6
2
SAFETY NOTES
2.1
Intended use
The
ricos
FLEX system is constructed and produced for:
•
communication and process control
•
industrial applications
•
operation within the environmental conditions specified in the technical data
•
installation into a control cabinet
This device is not certified for applications in in explosive environments (EX-zone).
2.2
Product disposal
National rules and regulations apply to the disposal of the unit!
2.3
General information
Please, observe the following instructions:
The
ricos
FLEX system may only be used in accordance with current international and national regu-
lations, as well as in accordance with all special restrictions on the use of the
ricos
FLEX system in
prescribed applications and environments.
Only use original accessories to prevent injuries as well as damage to the devices and to ensure that
all relevant regulations have been adhered to. Prohibited changes or the use of non-approved ac-
cessories may damage the system and violate existing laws. Prohibited changes or the use of non-
approved accessories may result in the invalidity of warranty claims.
Voltage at the
ricos
FLEX system must not be exceeded.
Do not expose the
ricos
FLEX system to extreme ambient conditions. Protect the system against
dust, moisture and high temperature.
When using the
ricos
FLEX system in the close proximity of personal medical devices, such as cardiac
pacemakers or hearing aids, you must proceed with heightened caution.
Any other application or change to the system – even during assembly and installation – will result
in the invalidity of any warranty claims against Wieland Electric GmbH.
The following conditions must be met before using or commissioning the components described in
this manual:
•
Hardware modifications to the process control system should only be carried out when the sys-
tem has been disconnected from power!
•
Installation and hardware modifications only by properly trained personnel.
•
The national rules and regulations of the respective country must be satisfied (installation, safety,
EMC ...)
DANGER
NOTICE
