Terra Clean 100
12 Troubleshooting
46
239 99 01
–
003
10 | 2020
11.8.
Unauthorized conversion and spare part manufacture
•
Only convert or change the machine with the express permission of the manufacturer!
•
The use of original parts and accessories authorized by the manufacturer is in the interest of your safety. Using parts
not released by the manufacturer can have a negative impact on the properties of the machine. In this case, the
manufacturer will assume no responsibility for the resulting consequences.
12.
Troubleshooting
Description
Cause
Solution
Absorption quality is unsatisfactory
•
Brush frequency may be too low.
➢
Increase the driving speed to a
maximum of 8 km/h.
Caution
!
When travelling around bends,
reduce speed to below 5 km/h.
•
Gap is too wide between baffle plate
and brushes.
➢
Check brushes, if necessary replace
strip brushes (see section 11.4.2.)
•
Cylinder broom set too high
➢
Set the adjustment one tooth deeper
or, where appropriate,
only make a fine adjustment on the
tension jack.
➢
Take account of the maximum
working depth of 3 mm.
•
Work site is badly littered
➢
Clean the area twice
➢
Adjust the cleaning intervals to the
level of contamination,
See section 11.2.1
•
Coarse dirt is blown and/or works its
way onto cleaned surfaces.
➢
For low leaf coverage, use the larger
cover.
➢
Set the front impact flaps according
to our specification and adjust
slightly, if necessary.
See section 8.2.4
The machine and/or cylinder broom is
only working on one side.
•
Different tyre pressures in the wheels.
➢
Check the tyre pressures and
correct, if necessary.
See section 11.6
•
Excessive clearance caused by worn
slide bearings
➢
Replace the slide bearings
Contact a specialist workshop
