Inteo Test Mode
The Test Mode allows the clinician to compare the output of the hearing aid against factory
specifications. The hearing aid is set to a fixed frequency gain setting during this measurement.
1. Turn off the iP5 by pressing [
ON R
] AND
[
ON L
] simultaneously.
2. Connect the Inteo hearing aid to the appro-
priate inlet [
ON L or ON R
].
3. Hold down the top right menu key while
pressing the appropriate [
ON
] key.
4. [
TEST MODE
] is displayed. The hearing aid
is in test mode.
5. Connect Inteo to the coupler of the hearing aid test system and follow ANSI-1996 for
evaluating the Inteo hearing aid.
6. Press [
TELE
] to evaluate telecoil function.
7. When testing a BTE instrument open the battery door, when testing is completed, to restore
the hearing aid to regular functioning.
Programming the RC3 Remote Control
1. Insert the batteries in the remote control and replace the compartment cover.
2 . Within 10 seconds, press and hold down the center key while pressing the upper left key (+).
3. The word Pro will appear in the display window.
4. Press the center key. The display window will show the RC3 model.
5. Press the center key. The display window will show the maximum number of programs the
remote can handle. Change the number of programs by using the up/down keys on the right
side of the remote. The number of programs in the remote must be the same number of pro-
grams in the hearing aid.
6. Press the center key. The display window will show the setting of the short-term log func-
tion. The default setting is off. Change the setting using the up/down keys on the right side
of the remote. Turning it on will enable the short-term logging feature of the aid.
7. To enable separate adjustment of the right and left hearing aids (RC3-2 only), press the cen-
ter key. The display window will show the current setting. The default setting is "Uni,"
which means the remote will adjust both aids simultaneously Use the up/down arrow keys
on the right side to change the setting to "Sep," which will adjust each aid individually.
8. To enable the timer function (RC3-2 only), press the center key. The display will show the
current setting of the timer function. The default setting is "AL OFF." Change the setting
using the up/down arrow keys on the right side of the remote.
9. To set the RC3 options, press the center key. The display window will show "Opt." All
options are set to default values, and it is normally not necessary to change these during
the initial programming of the RC3.
10. To end programming, press the center key again.
B
12
IN_IP5_Manual8.qxd 11/28/06 1:12 PM Page 12
