Wickes TRITON Aquatronic 3 ultra, Инструкция по установке и эксплуатации

Страница: 16 / 24

Aquatronic 3 ultra
OPERATING THE SHOWER
To start the shower
Press the START/STOP button and water will flow.
To stop the shower
Press the START/STOP button once more and
water will cease to flow.
To use the power selector
The power selector has three positions — COLD,
ECONOMy and HIGH
(fig.) .
The blue symbol is for COLD water only.
Adjusting the temperature control at this setting
will only change the force of the water from
the showerhead — it will not alter the water
temperature.
The red symbol
is the ECONOMy setting for
using less energy when the ambient mains water
temperature is high during warmer months.
Temperature adjustment at this setting is via the
temperature control.
note:
If the stated flow rate required for the unit
cannot be met due to low water pressure, it will
be necessary to operate the unit on this setting
during the warmer months because of flow rate
limitations entering the unit.
The red symbol is the HIGH power setting
which allows the highest flow achievable for
your preferred temperature. This setting should
normally be regarded as optimum shower
performance throughout the year. Temperature
adjustment at this setting is via the temperature
control.
WarnInG!
Before normal operation of the
shower, it is essential that the
commissioning procedure has been
completed correctly.
WarnInG!
If restarting immediately after
stopping, be aware that a slug of hot
water will be expelled for the first few
seconds.
High
Cold
Economy
Temperature
control
Power
selector
Start/Stop
button
Fig.
Temperature
control to
maximum
flow setting
Fig.