HOW TO INSTALL
BEFORE YOU START
If the tap is installed into a low pressure (tank fed) system, the minimum height from the outlet
of the nozzle to the underside of the water tank, should be at least 2 metres to ensure adequate
performance.
This product must be connected to the water supply in accordance with the Water Supply (Water
Fittings) Regulations 1999, and also to comply with UK Building Regulations. If you are in any doubt
about these requirements, contact a qualified plumber, your local Water Company or the Water
Regulations Advisory Service (WRAS).
a. Identify all components and check pack contents.
b. TURN OFF WATER MAINS SUPPLY. The mains stopcock is usually situated where the supply enters
the building.
c. It is also recommended that the water heating arrangements are turned off.
d. Isolate the hot and cold supply pipes and drain both water systems. It is recommended to ensure
complete drainage, that all taps are open. There is no need to drain the heating system.
PARTS SUPPLIED
LIST
Tap Body & Valve
Body Seating
Flange
Washer(Anti-Rotational)
Rubber Horseshoe Washer
Metal Horseshoe Washer
Fixing Nut
Threaded Studs
Braided Connector
1 SETS
1 PCS
1 PCS
1 PCS
1 PCS
1 PCS
1 PCS
1 PCS
2 PCS
