Wickes 223740, Руководство пользователя

Страница: 8 / 16

8
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the instruction book carefully.
WARNING!
Remove the mains plug from the
socket before changing sanding belt.
Pull the lever (9) to release the belt tension. Remove and
fit a new belt over both rollers. Ensure the direction of
rotation arrows on the belt and the sander are the same.
Close the lever to tension the belt.
WARNING! Wear eye protection before
carrying out a belt centering adjustment.
Turn the machine upside down, hold it firmly with one
hand, start the tool and release the switch immediately
after observing tracking of sanding belt. If the sanding
belt runs outward, turn tracking adjustment knob (7)
counter-clockwise, and clockwise if the sanding belt runs
inward. Adjust the sanding belt until the outer edge of
the sanding belt is even with the outer edge of the base-
plate. Belt life will be greatly increased by keeping the
tracking adjustment set properly.
1. INSTALLING THE SANDING BELT (See Fig A1, A2)
2. BELT CENTERING CONTROL (See Fig. B )
Fig. A1
Fig. A2
Fig. B
1
1
2
2 2
3
2
2
4