Copyright © 2016 Wi2Wi, Inc.
Page 12 of 20
# configure encryption:
./uaputl.exe sys_cfg_auth 0
./uaputl.exe sys_cfg_protocol 1 # Open
./uaputl.exe sys_cfg_wpa_passphrase hyderabad # passphrase "hyderabad"
./uaputl.exe sys_cfg_cipher 8 8 # CCMP
./uaputl.exe bss_start # start the AP
ifconfig uap0 192.168.1.1 # Assign IP Address
#Also enable DHCP server.
3.3
WiFi Direct Mode
3.4
Data Transfer
Data transfer can be done using iperf commands as shown below:
TCP server:
iperf -s
TCP Client:
iperf -c
'Dest IP' 'time' 'interval'
Note: Underlined arguments are optional
Ex:
iperf -c 192.168.1.1 -t 10 -i 1
The -t argument specifies the test duration time in seconds, default is 10 secs.
The -i argument indicates the interval in seconds between periodic bandwidth reports.
3.5
Driver Proc and Debug commands
Driver proc and debug commands are explained in "
README_MLAN.txt" file which is given with release
package.
3.6
Driver Configuration commands
The following commands are used to send additional commands to the Marvell MLAN card via the Linux
device driver. The mlanX parameter specifies the network device that is to be used to perform this command
on. It could be mlan0, mlan1 etc.
mlanutl is used to configure the additional parameters available for WiF driver. For more details refer " USER
MANUAL FOR MLANUTL" in " README_MLAN.txt" file which is given with release package.
Содержание W2SW0025
Страница 1: ...User Manual Revision 0 2 January 29 2016...
