Whyte 905, Инструкция по эксплуатации

Страница: 18 / 40

Page 18
General Instruction Manual
WARNING: Securely clamping the wheel with a cam action
retention device takes considerable force. If you can fully
close the cam lever without wrapping your fingers around the
fork blade for leverage, the lever does not leave a clear
imprint in the palm of your hand, and the serrations on the
wheel fastener do not emboss the surfaces of the dropouts,
the tension is insufficient. Open the lever; turn the tension
adjusting nut clockwise a quarter turn and try again.
If you disengaged the brake quick-release mechanism to remove the wheel, re-
engage it to restore correct brake pad-to-rim clearance. Follow the manufacturer’s
instructions or ask your Whyte dealer to make sure that you understand the way the
brake quick release works on your bike.
Spin the wheel to make sure that it is centered in the frame and clears the brake
pads; then squeeze the brake lever and make sure that the brakes are operating
correctly.
For a Through Axle retention device (figure 9):
With the steering fork facing forward, insert the wheel
between the fork blades so that the axle seats firmly at the
top of the fork dropouts. Note that the brake disk should be
located on the left side of the bicycle (rider facing forwards).
Insert the through axle (figure 9) from the right side (SRAM)
or left side (Fox / Shimano) until it engages in it’s thread.
Make sure the cam lever of the retention device is in the OPEN
position (figure 14) and turn the cam lever clockwise until
hand tight. If Fox / Shimano then unwind until the cam lever
is opposite the location where it was previously unlocked
from.
Swing the cam lever into the CLOSED position (figure 15). To
apply enough clamping force, you should have to wrap your
fingers around the fork blade for leverage, and the lever
should leave a clear imprint in the palm of your hand.
NOTE:
If the cam lever cannot be pushed all the way to a
position parallel to the fork blade, follow the manufacturer’s
instructions for adjustment or consult your Whyte dealer.
WARNING: Securely clamping the wheel with a cam action
retention device takes considerable force. If you can fully
close the cam lever without wrapping your fingers around the
fork blade for leverage and the lever does not leave a clear
imprint in the palm of your hand, the tension is insufficient.
If you disengaged the brake quick-release mechanism to remove the wheel, re-
engage it to restore correct brake pad-to-rim clearance. Follow the manufacturer’s
instructions or ask your Whyte dealer to make sure that you understand the way the
brake quick release works on your bike.
Spin the wheel to make sure that it is centered in the frame and clears the brake
pads; then squeeze the brake lever and make sure that the brakes are operating
fig. 14
fig. 15