Whynter BWR-281DZ, Инструкция по эксплуатации

Страница: 17 / 19

Page 17
TROUBLESHOOTING GUIDE
Most common problems can be resolved by referring to the troubleshooting suggestions listed below.
PROBLEM POSSIBLE CAUSE SOLUTIONS
The appliance does
not operate.

There is a power failure.

The appliance is not plugged in.

A house fuse has blown or the circuit
breaker is tripped.

Ensure the appliance is plugged in
and the power outlet has power.

Replace the broken fuse or reset
the breaker.
The appliance is not
cold enough.

The set temperature too high.

The appliance is placed too close to a
heat source.

The door is opened too often.

The door is not closed completely.

The door gasket does not seal properly.

The front bottom grille does not have
sufficient ventilation.

Adjust the set temperature

Keep the appliance away from
sunshine or other heat sources.

Close the door tightly and do not
open the door too frequently or for
a long period of time.

Ensure the door gasket is not
loose. The front bottom grille must
be completely unobstructed.
The appliance turns
on and off frequently.

The ambient (room) temperature is too
low or high.

A large amount of contents has been
added to the appliance.

The door is opened too often.

The door is not closed completely.

The door gasket does not seal properly.

Decrease or increase the ambient
(room) temperature.

To minimize internal temperature
fluctuation, do not add large
amount of contents at once.

Close the door tightly and do not
open the door too frequently or for
a long period of time.

Ensure the door gasket is not loose.
The appliance makes
too much noise.

The noise may come from the flow of
the refrigerant/

Contraction and expansion of the inside
walls may cause popping and crackling
noises.

The appliance is not level.

It is normal that as each cooling
cycle ends, you may hear rattling or
gurgling sounds caused by the flow
of refrigerant in the appliance. The
high efficiency compressor may
make a pulsating or high pitched
sound.

Some popping or cracking noises
are normal. They are caused by
expansion and contraction of the
inside walls due to temperature
changes.

Make sure the unit is on a hard
and level surface. Do not place
the appliance on carpet.
The door does not
close properly.

The appliance is not level.

The door was reversed and not
properly installed.

The shelves are out of position.

Make sure the cooler is on a hard
and level surface. Avoid placing the
appliance on a carpeted or soft
surface.

Correctly install the shelves.