1614a; 1620a; 1626a & 1632a McKenzie Alder Hutch
Assembly Instructions
1614a_1620a_1626a_1632a_Finished — Page 7 — 07/17
4.
It is important you secure your Hutch to your Cabinet. Place the Hutch on top of the McKenzie
Alder Cabinet and line it up with the back and sides. Find the Lock Plates (N) attached at each
side of the Hutch near the bottom edge and remove the innermost screw (I) from each. Rotate
the end of the Plate downward until the hole for the screw is centered on the back edge of the
top of the Cabinet. Insert the screws into the Cabinet to secure the Hutch as shown in Figures 4
and 4a. For additional stability, insert a #8 x 1-1/4" Pan Head Screw (J) through the pocket hole
located behind the face molding on each side panel on the Hutch. Note this will create two holes
in the top of the Cabinet. See Figures 4b and 4c.
5.
Your Base unit includes a Tipping Restraint Kit to secure the completed item to the wall to
protect from possible tip over hazards. If you are attaching this Hutch to an older Cabinet and
no longer have the Tipping restraint kit, use the Kit included with this Hutch to secure the
item. Attach the end of the Strap to the Bottom Shelf of your Cabinet unit near the back edge at
the center of the item, and follow the instructions in the Tipping Restraint Kit.
Fig. 4
I
Fig. 4a
N
Fig. 4b
Fig. 4c
Back on the Hutch removed for illustration purposes.
J
