3506AFGACa; 3506AFCAFa McKenzie Console Desk
Assembly Instructions
3506AFGACa_3506AFCAFa
— Page 4 — 05/13
Tools Required: Hex Wrench (provided); Phillips Screwdriver, Mallet or Padded Hammer.
1.
Remove the Hutch Drawers (H) from the Case Assembly (C). Turn the Case Assembly (C)
upside-down on a clean protected surface. Using the Hex Wrench (ZH) attach the Left Side
Assembly (D) to the case assembly with two 1/4" x 40mm Bolts (ZE). Fasten securely. Make
sure the dowel is fully seated in place by tapping the Left Side Assembly (D) with a rubber
mallet. See Figure 1.
2.
Using the Hex Wrench (ZH) attach the Right Side Assembly (E) to the case assembly with two
1/4" x 40mm Bolts (ZE). Fasten securely. Make sure the dowel is fully seated in place by
tapping the Right Side Assembly (E) with a rubber mallet. See Figure 2.
Fig. 1
ZE
x 2
ZE
D
Tap this area with
a rubber mallet.
Fig. 2
ZE
x 2
ZE
E
Tap this area with
a rubber mallet.
