3460AFCAFa Stayton Media Console;
3462AFCAFa Stayton Media Center
Assembly Instructions
3460AFCAFa_3462AFCAFa
— Page 7 — 03/14
10. Position the unit at the desired location. Locate a stud in the wall behind the unit near each Leg.
Do not choose a stud that will be located behind the center back panel. A strong small magnet
is helpful to locate the studs in the wall. The magnet will help you find the nails or screws used
to attach the wall to the studs. When you have found a screw you have found a stud. Studs are
usually 16" on center. Attach a Clip (T1) to each wall stud with #8 x 2" Black Screws (T3). See
Figure 10a.
The clips attached to the furniture must penetrate solid wood such as the back apron or a leg.
Do not attach where it will be screwed only into the thin back panel. Attach the second clip from
each kit to the unit with #6 x 5/8" Philtruss Screws (T5). See Figure 10b. Connect the two clips
with the Nylon Zip-Tie (T2).
Pull the Nylon Zip-Tie (T2) tight so there is no slack
. See
Figures 10c and 10d. We have included an extra Nylon Zip-Tie in each kit; if you should need to
move your furniture cut the Zip-Ties that you are using and replace with the extra Zip-Ties when
the furniture is back in place.
The screws attaching your furniture to the wall must be inserted
into a wall stud. Do not attempt to use wall anchors.
Pull tight
Wood
Stud
Fig. 10c
Pull the Nylon Zip-Tie (T2)
tight so there is no slack. T1
T2
T5
T3
(Side view)
Fig. 10a
T1
T3
T5
Top
Fig. 10b
Fig. 10d
Wood
Stud
Back
