Whitfield ADVANTAGE PLUS Скачать руководство пользователя страница 5

Страница: 5 / 37

Detailed Safety Precautions

Fuel -

With its advanced UltraGrate technology, the Whitfield Advantage Plus is designed and approved for

the burning of wood residue pellets with up to 3% ash content (i.e...cardboard, nut hulls, cherry pits etc.).
The burning of agricultural residues (i.e.... corn, alfalfa etc.) in pellet form is not permitted. Failure to com-
ply with this restriction will void all warranties and the safety listing of the stove. Consult with your dealer
for more information on approved pellet fuels and the proper burn grate for the fuels in your area.

Cleaning -

There may be some build-up of dust and smaller quantities of soot or creosote in the exhaust

system over the burn season. This will vary due to the ash content of the fuel being burned. A precaution-
a ry inspection on a regular basis is advisable to determine the necessity of cleaning.

Continuous Operation -

When operated correctly, the Whitfield Advantage Plus cannot be over-fired.

Continuous operation at a maximum burn can, however, shorten the life of the electrical components
(blowers, motors, and electronic controls), and is not recommended. Typical approved operation would
include running at setting numbers Two, Three or Four, with occasional running on number Five during
the coldest periods of the winter. The blower speed control should be turned to #5 when operating the
stove on the number five heat setting.

Liquid Flammables -

Gasoline or other flammable liquids must

NEVER

be used to start or “freshen-up” the

fire. Keep all such liquids well away from the stove at all times.

Ashes -

Any ashes removed from the Whitfield Advantage Plus must be deposited in a metal container

with a tight-fitting lid. The closed container of ashes should be placed on a noncombustible floor or on
the ground, well away from all combustible materials, pending final disposal. If the ashes are disposed of
by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cin-
ders have been thoroughly cooled.

Power -

The appliance is provided with a detachable, grounded electrical cord. This cord should be

plugged into a standard, 115 volt, 60 Hz grounded electrical outlet. The approximate power requirement
is 200 watts, or will peak to approximately 700 watts for 15 minutes when the self-igniter is operating. The
power supply cord must be routed to avoid contact with any of the hot or sharp exterior surface areas of
the stove. In addition, any Whitfield Advantage Plus stove that is installed in a mobile home must be:
Connected to a source of outside air, Electrically grounded to the steel chassis and Bolted to the floor in
compliance with and according to H.U. D. requirements unless otherwise specified by state or local authori-
t i e s .

Soot Formation -

For all wood pellet fuel-burning heater products the combustion gases will contain small

particles of fly ash. The fly ash will collect in the exhaust venting system and restrict the flow of the flue
gases, over time. Incomplete combustion, such as occurs during startup, shutdown, or incorrect operation
of the room heater will lead to some soot formation which will collect in the exhaust venting system. The
exhaust venting system should be inspected at least once every year to determine if cleaning is necessary.

Safety Precautions

Safety Notice

THIS STOVE MUST BE PRO P E R LY INSTALLED AND OPERATED IN ORDER TO PREVENT THE POSSIBILITY OF
A HOUSE FIRE. PLEASE READ THIS ENTIRE OWNER’S MANUAL BEFORE INSTALLING AND USING YO U R
WHITFIELD PELLET S TOVE. FA I LURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN PRO P E RT Y
DA M AGE, BODILY INJURY OR EVEN DEATH. CO N TAC T YOUR LOCAL BUILDING OR FIRE OFFICIALS TO
O BTAIN A PERMIT AND INFORMATION ON ANY INSTA L L ATION RESTRICTIONS AND INSPECTION
REQUIREMENTS IN YOUR AREA.

Installation Disclaimer

THIS STOVES EXHAU S T SYSTEM WORKS WITH NEGATIVE COMBUSTION CHAMBER PRESSURE AND A
S L I G H T LY POSITIVE CHIMNEY PRESSURE. THEREFORE, IT IS IMPERATIVE THAT THE EXHAU S T SYSTEM BE
GAS TIGHT AND INSTALLED CO R R E C T LY. SINCE PY RO INDUSTRIES, INC., HAS NO CO N T ROL OVER THE
I N S TA L L ATION OF YOUR STOVE, PY RO INDUSTRIES GRANTS NO WA R R A N T Y, IMPLIED OR
S TATED FOR THE INSTA L L ATION OR MAINTENANCE OF YOUR STOVE, AND ASSUMES NO
RESPONSIBILITY FOR ANY CONSEQUENTIAL DA M AG E ( S ) .